change CRTD STATUS TO REL FOR while mapping Sample Drawing Procedure.

Hello,

I am trying to use Physical Sample Management in SAP for Inspection

Lots with Inspection Type 04. Every time I create an inspection lot, my lot

stays in Created mode. Here's my data.

I created a Sample Drawing

Procedure with the following info:

Lot Container: EA

ToPartSampleNo:

1

Sample Container: PALLET

Size Factor: 1

Fixed Number: 2

I

SAMPLE SCHEME

lot size-30

sample size-29

c1-21

d1-22

also created a Sampling Procedure with the following:

Sampling Type: 300 USE SAMPLING SCHEME

Sample

Valuation Mode: 100

Inspection

Points: Sample Management

Sample Size: 3

I assigned Inspection Point

200 and the Sample Drawing Procedure to the header of my Inspection Plan.

Is there something I am doing

wrong?

lot is generated but unable to go ahead.