Initially i created a sampling procedure,i had opted for free inspection points & done some recording results & taken UD. Then i changed the sampling procedure i removed the option of "Inspection points" & chose sample management.I have cleared the inspection lots also.
For a new material in inspection plan when i try to assign Sample procedure i am encountering a error message.
The sampling procedure can only be used for inspections with insp. points
Message no. QD242
Diagnosis
The specified sampling procedure can only be used for inspection-point-related inspections and is, therefore, not allowed in this environment.
System Response
You cannot select this sampling procedure.
Procedure
Choose a different sampling procedure.
Is it not possible to use the old sampling procedure should i create a new sampling procedure even after i have created the inspection lots?
