I'm thinking about putting in an OSS note on this but I'd like to see if any other people see this same behavior.
In QA32, I can go to the dynamic selections and add "Vendor Batch" as a selection item.
In the selection screen I enter in a material number that I know has inspection lots out there and that I know has the "Vendor Batch" field populated in the batch master.
I then execute the selection and QA32 returns no inspection lots.
If I remove the vendor batch number from the selection criteria and rerun just using material number, I get many batches of the material.
If I put in the vendor batch number and execute again, no inspection lots are found.
I would think this is a bug. Can someone else verify what I'm seeing? I couldn't find any OSS notes on this nor could I find any discussion on this. If it can be verified some where else, I'll put up an OSSS note on it.
This is a 6.0 system. NO EHP 4.
Craig
